Building a custom PTO driveline or repairing a damaged shaft assembly? This Weasler 44 series shaft weld yoke is engineered to handle the heavy-duty demands of larger tractors and implements, with 1-5/16 inch cross bearing caps and a 4-inch bearing length that delivers reliable power transfer under tough conditions. When you need a yoke that welds cleanly to your shaft and keeps working season after season, this is the piece that gets the job done.
What You’re Getting
- Heavy-duty 44 series construction with 1-5/16 inch bearing cap diameter for maximum strength
- 1-5/16 inch square bore that fits standard square shafts perfectly
- Weasler’s forged tough construction, machined to tight tolerances so it slides on smooth but doesn’t develop slop
- 4-1/8 inch center-to-end measurement that works with properly sized driveline assemblies
Built for Real Farm Work
The 44 series is right at home on heavy-duty implements and larger tractors where serious torque demands exceed what smaller series can handle. You’ll find these components on everything from large rotary cutters and heavy-duty tillers to commercial mowers and other high-horsepower PTO applications. The bearing surfaces are ground smooth and the cross assembly is built to handle constant speed changes and angles that come with real field work – this isn’t a hardware store universal joint that’ll leave you stranded.
Made to Last
Weasler doesn’t mess around – their yokes are forged tough and machined to tight tolerances. The square bore design provides positive engagement with your shaft, and the heavy-duty construction stands up to the vibration, shock loads, and constant flexing that comes with farm equipment operation. This is agricultural-grade quality that’ll keep working when cheaper alternatives have long since failed.
Good to Know
This is a weld-on yoke designed for custom shaft fabrication or repair work. Make sure your shaft diameter matches the 1-5/16 square bore size before welding. Series compatibility is important – this 44 series yoke needs to mate with other 44 series components for proper fit, and that 4-1/8 inch center-to-end measurement needs to work with your driveline length. Always verify your measurements before starting any welding work.
